| |
 |
|
PASS Ball-Deburring Tool V3for TRUMPF punching machines
|
06.06.2011 |
Double-side deburring close to edges
» Read more... |
 |
|
PASS Knock-Out Technologyfor defined knock-outs direct at bendings
|
06.06.2011 |
In the daily life, installers and electricians are confronted with the challenge to position cables in the correct position of an electrical case. Therefore knock-outs punched into the sheets are designed to make it easier for the installer to remove on-site knock-outs that best fit their needs.
» Read more... |
 |
|
PASS Step Plate Toolfor TRUMPF punching machines
|
26.10.2010 |
Step plates can particulary be found in construction of vehicles, waggon or shipbuildings, for bridges and ramps.
» Read more... |
 |
|
PASS Double Louver Toolfor TRUMPF punching machines
|
26.10.2010 |
The double louver is produced up- and downwards with ONE hit. Total emboss height = 10 mm
» Read more... |
 |
|
PASS Tool Cassettesfor machine type Salvagnini S4
|
26.10.2010 |
PASS Tool Cassettes for machine type Salvagnini S4
» Read more... |
|
|
| |
|
|
|
|
|
|
